|
14 (800x600)
the frame drops in to the roll bar slots at the vehicle side and are secure with a pin
Date: 05/02/04
Views: 123
|
15 (800x600)
frane is made of 30 mm steel steam tube which has a wall gauge of 3 mm
Date: 05/02/04
Views: 105
|
16 (800x600)
view showing showing detail of frame
Date: 05/02/04
Views: 111
|
|
17 (800x600)
fixings were done without the need to drill any holes that were not there before
Date: 05/02/04
Views: 103
|
18 (800x600)
as you can see
Date: 05/02/04
Views: 101
|
19 (800x600)
tapped for bolts, the top now can be lifted off in two sections if it gets a bit warm
Date: 05/02/04
Views: 108
|
|
20 (800x600)
not a complicated construction but very strong and is as good as a roll bar.
Date: 05/02/04
Views: 103
|
26 (800x600)
photo 1 of canvas
Date: 09/28/07
Views: 103
|
29 (800x600)
shows places where turn buckles were used
Date: 09/28/07
Views: 105
|
|
31 (800x600)
fixing points
Date: 09/28/07
Views: 127
|
34 (600x800)
door construction was copied from willis jeep
Date: 09/28/07
Views: 137
|
36 (600x800)
framework is made of 10 mm steel bar
Date: 09/28/07
Views: 141
|
|
39 (800x600)
rear window of plastic as in doors
|
mirror 005 (600x800)
mirror was copied of my valp so it can be moved when you open door and then springs back when you shut the door. this top is a mk 2, the original idea was by jonas's mk 1
Date: 09/11/09
Views: 137
|
engine heater (640x480)
motervarmer ready for use
|
