|
14 (800x600)
the frame drops in to the roll bar slots at the vehicle side and are secure with a pin
|
15 (800x600)
frane is made of 30 mm steel steam tube which has a wall gauge of 3 mm
|
16 (800x600)
view showing showing detail of frame
|
|
17 (800x600)
fixings were done without the need to drill any holes that were not there before
|
18 (800x600)
as you can see
|
19 (800x600)
tapped for bolts, the top now can be lifted off in two sections if it gets a bit warm
|
|
20 (800x600)
not a complicated construction but very strong and is as good as a roll bar.
|
26 (800x600)
photo 1 of canvas
Date: 9/28/2007
Views: 35
|
29 (800x600)
shows places where turn buckles were used
Date: 9/28/2007
Views: 35
|
|
31 (800x600)
fixing points
Date: 9/28/2007
Views: 30
|
34 (600x800)
door construction was copied from willis jeep
Date: 9/28/2007
Views: 43
|
36 (600x800)
framework is made of 10 mm steel bar
Date: 9/28/2007
Views: 46
|
|
39 (800x600)
rear window of plastic as in doors
Date: 9/28/2007
Views: 30
|
mirror 005 (600x800)
mirror was copied of my valp so it can be moved when you open door and then springs back when you shut the door. this top is a mk 2, the original idea was by jonas's mk 1
Date: 9/11/2009
Views: 47
|
engine heater (640x480)
motervarmer ready for use
Date: 2/15/2004
Views: 18
|
